If you want to improve your internet speed and eliminate weak signal areas at home or work, consider Netgear AC750 Setup. This device, called the AC750, acts as a Wi-Fi range extender and can provide fast speeds up to 1200 Mbps.

The Netgear AC750 is designed to extend your wireless network's coverage. It works by taking the existing wireless signal from your router and transmitting it to areas where the signal is weak, effectively getting rid of dead zones and expanding your network's reach. Plus, it's straightforward to set up and can work with any wireless router. It even has Ethernet ports, allowing you to connect wired devices to your extended network.

There are two ways to set up the Netgear AC750:

• WPS Setup: This is a quick and easy method.

• Manual Setup: This method requires a bit more work but gives you more control.

Netgear AC750 Setup with WPS Method

Follow the steps for Netgear AC750 Setup by WPS button :

• Unwrap and turn on your Netgear AC750.

• Place it near your router.

• Wait for the power LED to turn green.

• Press the WPS button on the extender.

• After a moment, press the WPS button on your router.

• If all the LEDs on the extender turn green, your setup is complete.

• Connect your devices to the extender and place it in areas with weak signals.

This is a quick way to get your Netgear AC750 up and running.

Netgear AC750 Setup with Manual Method

• Connect the AC750 to your modem using an Ethernet cable.

• Plug the AC750 into a power source and turn it on.

• Connect a computer or device to the AC750 using another Ethernet cable.

• Open a web browser and enter the AC750's IP address in the address bar (usually "192.168.1.250").

• Log in using the default username "admin" and password "password."

• Configure your AC750 settings as needed.

Note: Remember to change the default login information for security.

Updating Netgear AC750 Firmware

It's essential to keep your Netgear AC750's firmware up to date for security and performance improvements. Here's how:

• Power on your Netgear AC750.

• Connect to your existing Wi-Fi network.

• Open your web browser and go to mywifiext.net, Netgear's official website.

• Log in with your personal information.

• Navigate to the firmware upgrade section in the settings.

• During the update, avoid disconnecting your AC750.

By following these steps, you can ensure your AC750 is running the latest firmware for optimal performance and security.

Resetting Netgear AC750 Extender

If you ever need to reset your AC750, follow these steps:

• Locate the reset button, usually on the device's bottom or rear.

• Use a paperclip or similar object to press and hold the reset button for 7 to 10 seconds.

• Release the reset button when the AC750's lights flash and then turn off.

• Wait a few minutes for the lights to come back on.

• Reconnect your computer or device to the AC750 and set it up again as desired.

Keep in mind that resetting the AC750 will erase all settings and configurations, so have your login information and network settings ready before resetting the device.